Honda Accord 2008 Manual page 1584

07/11/02 09:28:33 61TA0000_200_0017
14. Remove the switch panel (A) and the armrest (B) as
an assembly from the door panel (C).
–1 Remove the screws from the back of the door
–2 Pull out along the edge of the armrest to
–3 Pull out along the edge of the switch panel to
＊１１
Fastener Locations
: Screw, 7
D
C
15. Remove the screws, and release the hook (A), then
separate the switch panel (B) and the armrest (C).
＊１２
Fastener Locations
: Screw, 3
C
panel.
release all of the hooks (D).
release the hooks (E) and to detach the clips.
: Clip, 3
B
A
16. Install the door panel in the reverse order of
removal, and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Replace any damaged cable fasteners with new
ones.
• The latch cable (A) should be fixed to the cable
fastener (B) with the latch in the unlocked
position as shown.
• Make sure the connectors are plugged in
properly, and the cables are connected securely.
• Make sure the window and power door lock
operate properly
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
E
A
B
B
A
47 mm (1.85 in.)
＊１３
20-15