Key Interlock System Circuit Troubleshooting - Honda Accord 2008 Manual

07/11/02 09:20:43 61TA0000_140_0307

Key Interlock System Circuit Troubleshooting

SRS components are located in this area. Review the
SRS component locations for 4-door (see page 24-19),
for 2-door (see page 24-21) and the precautions and
procedures (see page 24-23) before doing repair or
service.
1. Turn the ignition switch to ACCESSORY (I). The
shift lever must be in P.
2. Disconnect the steering lock assembly connector.
3. Check if the ignition switch can be turned to
LOCK (0).
Can the ignition switch be turned to LOCK ( 0)?
YES
NO −
assembly (see page 17-34).
4. Turn the ignition switch to LOCK (0).
5. Move the shift lever out of P.
6. Check for continuity between steering lock
assembly connector terminal No. 3 and body
ground.
＊０１
Is there continuity?
YES
between the key interlock solenoid and the
MICU.
−
NO
7. Remove the shift lever assembly (see page 14-273).
− Go to step 4.
Replace the ignition key cylinder/steering lock
STEERING LOCK ASSEMBLY CONNECTOR
KEY SOL (BLU)
Wire side of female terminals
−
Repair short to body ground in the wire
Go to step 7.
8. Check for continuity between park pin switch/A/T
gear position indicator panel light connector
terminal No. 1 and body ground.
PARK PIN SWITCH/
A/T GEAR POSITION INDICATOR
PANEL LIGHT CONNECTOR
P-PIN (WHT)
Wire side of female terminals
Is there continuity?
−
YES Repair short to body ground in the wire
between park pin switch/A/T gear position indicator
panel light connector terminal No. 1 and the
MICU.
NO − Go to step 9.
9. Shift into P.
10. Check for continuity between park pin switch/A/T
gear position indicator panel light connector
terminals No. 1 and No. 2. Do not push the shift
lever button.
PARK PIN SWITCH/
A/T GEAR POSITION INDICATOR
PANEL LIGHT CONNECTOR
P-PIN (GRN) GND (GRN)
Terminal side of male terminals
Is there continuity?
−
YES Replace the park pin switch (see page
14-314).
NO − Go to step 11.
ＴＡ０８ＡＡ１Ｅ１０４３６４３６０２１ＦＡＡＴ１０
＊０２
＊０３
(cont'd)
14-305