Honda Accord 2008 Manual page 1126

07/11/02 09:19:53 61TA0000_140_0283
8. Saitama Factory produced models: Remove the
shift cable cover (A).
＊０５
F
9. Saitama Factory produced models: Remove the
spring clip (B) and the control pin (C), and separate
the shift cable end (D) from the control lever (E).
Remove the two bolts securing the shift cable
bracket (F).
10. Marysville, Ohio Factory produced models:
Remove the shift cable cover (A), and remove the
two bolts securing the shift cable bracket (B).
＊０６
B
A
11. Marysville, Ohio Factory produced models: Pry up
the lock tab of the lock washer (C), and remove the
lock bolt (D) and lock washer, then separate the
shift cable (E) from the control shaft (F).
E
12. Remove the heat shield.
C
B
D
A
13. Remove the bolts securing the shift cable stay (A).
A
F
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
14. Remove the shift cable grommet (B), and pull out
the shift cable (C).
C
15. Insert a new shift cable through the grommet hole
(D), and install the grommet in its hole. Do not bend
D
the shift cable excessively.
16. Secure the shift cable grommet.
E
＊０７
＊０８
D
C
B
(cont'd)
14-281