Honda Accord 2008 Manual page 1311

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:20:17 61TA0000_170_0045

Power Steering

Steering Gearbox Overhaul (cont'd)

Special Tools Required

• Cylinder end seal remover attachment

07TAF-SZ50100

• Valve seal ring sizing tool 07NAG-SR3090A

• Sleeve seal ring guide 07YAG-S2X0100

• Sleeve seal ring sizing tool, 36 mm 07ZAG-S5A0100

• Attachment, 28 x 30 mm 07946-1870100

• Driver 07749-0010000

• Piston seal ring guide 07XAG-S0KA200

• Oil seal driver, 65 mm 07JAD-PL9A100

• Attachment, 30 mm I.D. 07746-0030300

• Piston seal ring sizing tool 07HAG-SF1020A

• Pincers Oetiker 1098 or equivalent, commercially

1. Remove the steering gearbox (see page 17-36).

2. Remove the tie-rod end from the rack end.

3. Drill a 4.0 mm (0.16 in.) diameter hole about 2.5

3.0 mm (0.10 0.12 in.) in depth in the staked points

(A) on the end plug (B) and the gearbox housing (C).

4. Remove the end plug (A) from the gearbox housing,

then remove the self-locking nut (B) from the pinion

5. Remove the boot bands (A) and tie-rod clips (B).

Pull the boot away from the ends of the steering

Chapters

Table of Contents