Honda Accord 2008 Manual page 1072

07/11/02 09:18:09 61TA0000_140_0229
8. Remove the mounting bolts (F), then hold the shift
solenoid valve body and remove the shift solenoid
valves. Do not hold the connector to remove the
shift solenoid valve.
＊０４
9. Install new O-rings (two O-rings per shift solenoid
valve) (G) on the shift solenoid valve.
NOTE: A new shift solenoid valve comes with new
O-rings. If you install a new shift solenoid valve,
use the O-rings provided with it.
10. Install shift solenoid valve C (brown connector), D
(black connector), and E (black connector) by
holding the shift solenoid valve body; make sure
the mounting bracket contacts the servo body.
NOTE: Do not hold the shift solenoid valve
connector to install the shift solenoid valve. Be sure
to hold the shift solenoid valve body.
11. Install shift solenoid valve B (brown connector) by
holding the solenoid valve body; make sure the
mounting bracket contacts the bracket of shift
solenoid valve E.
G
G
D F
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
G
8.7 lbf·ft)
C
A
B
E
A
D
12. Install shift solenoid valve A (brown connector) by
holding the shift solenoid valve body; make sure
the mounting bracket contacts the bracket of shift
solenoid valve D.
NOTE: Do not install shift solenoid valves A or B
C
before installing shift solenoid valves D and E. If
shift solenoid valve A or B is installed before
F
installing shift solenoid valve D or E, it may
damage the hydraulic control system.
G
13. Connect the shift solenoid wire harness terminals
E
to shift solenoid valves:
G
• RED wire connector to shift solenoid valve E.
F
• GRN wire connector to shift solenoid valve C.
• ORN wire connector to shift solenoid valve B.
B
• BLU wire connector to shift solenoid valve A.
• YEL, WHT, and WHT wire connector to shift
solenoid valve D.
14. Install a new gasket, the dowel pins, and the shift
solenoid valve cover.
15. Check the connector for rust, dirt, or oil, clean or
repair as needed, then connect the connector
securely.
16. Refill the transmission with ATF (see step 4 on page
14-242).
17. Install the splash shield.
18. Install the left front wheel.
14-227