Honda Accord 2008 Manual page 1681

07/11/02 09:32:30 61TA0000_200_0114
Interior Trim
Trim Removal/Installation - Pillar Areas (cont'd)
6. Remove the C-pillar trim (A).
–1 Pull the top of the trim back by hand to remove
–2 Pull the bottom of the trim out by hand to
–3 Release the rear hook (G) from the rear shelf by
＊１６
G
20-112
the rear clip (B) from the body (C).
detach the hooks (D) from the rear side trim
panel (E) and the rear shelf (F).
pulling the trim forward.
A
B
D
A
F
D
7. If the side curtain airbag has been deployed,
replace the C-pillar trim and the C-pillar lid cap with
new ones (see page 24-203).
8. If the side curtain airbag has not been deployed,
check the C-pillar trim (A) and note the following:
• To prevent the side curtain airbags from
deploying improperly and possibly causing
injury, inspect the C-pillar trim and replace it if it
has any of these types of damage:
– Any cracks, deformations, or stress-whitened
C
areas in the C-pillar trim, the C-pillar lid (B),
and the C-pillar brackets (C).
– Any C-pillar brackets which have come off the
C-pillar trim or the C-pillar lid.
– Any cracks or stress-whitened areas in the clip
seating surfaces (D).
– Any cracks or stress-whitened areas in the
C-pillar lid cap (E).
• Remove the grommet (F) from the pin (G), and
discard the grommet because it was damaged
during removal.
E
• Replace the grommet with a new one.
• Do not install the grommet to the pin before
checking the overlap between the headliner and
the C-pillar trim.
• If the clips (H) are damaged or stress-whitened,
replace them with new ones.
G
D
F
E
B
C
C
A
＊１７
G
D