Stabilizer Bar Replacement - Honda Accord 2008 Manual

07/11/02 09:28:43 61TA0000_180_0048
Rear Suspension

Stabilizer Bar Replacement

1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the rear wheels.
3. Disconnect both stabilizer links from the stabilizer
bar (see page 18-47).
4. Remove the flange bolts (A) and the bushing
holders (B), then remove the bushings (C) and the
stabilizer bar (D).
NOTE: During installation, align the paint marks (E)
on the stabilizer bar with the side of the bushings.
＊０１
18-48
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
E
16 lbf·ft)
FRONT
C
B D
5. Install the stabilizer bar in the reverse order of
removal, and note these items:
• Note the right and left direction of the stabilizer
bar.
• Note the direction of installation for the bushing.
• Refer to the stabilizer link removal/installation to
connect the stabilizer bar to the links (see page
18-47).
• Before installing the wheel, clean the mating
surfaces of the brake disc and the inside of the
wheel.
• Check the wheel alignment, and adjust it if
necessary (see page 18-5).
ＴＡ０８Ａ００Ｂ４４１０００５６８５１ＫＢＡＴ００