Honda Accord 2008 Manual page 1384

07/11/02 09:28:45 61TA0000_180_0051
3. Loosely install the new damper lower mounting
bolt (A) on the bottom of the damper. Connect the
stabilizer link (B) to the brake hose bracket (C) to the
knuckle, and loosely install the new self-locking nut
(D).
＊０８
C
4. Place a floor jack under the connecting point of the
knuckle and lower arm A, and raise the suspension
to load with the vehicle's weight.
5. Tighten the damper lower mounting bolt and the
self-locking nut while holding the joint pin (E) with
the hex wrench (F) to the specified torque values.
6. Tighten the damper mounting nuts on top of the
damper to the specified torque value.
A
12 x 1.25 mm
64 N·m (6.5 kgf·m, 47 lbf·ft)
Replace.
B
7. Install the lid (A), and set the rear seat-back to the
original position.
4-door
D
10 x 1.25 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
Replace.
E
2-door
F
8. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the rear wheel.
9. Check the wheel alignment, and adjust it if
necessary (see page 18-5).
A
A
18-51
＊０９
＊１０