Honda Accord 2008 Manual page 1686

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:32:32 61TA0000_200_0119

8. If the new C-pillar trim (A) will be installed, before

installing the trim, temporarily remove new upper

9. Check the overlap between the headliner and

C-pillar trim, and if necessary, adjust it (see page

10. Carefully reinstall a new upper clip (A) to the

C-pillar trim (B). Be sure that the grommet (C) is

nearest to the top of the pin (D) as shown.

11. If the old C-pillar trim (A) will be reinstalled, install

the new grommet (B) to the pin (C). Do not push the

grommet too hard. Be sure that the grommet is

nearest to the top of the pin as shown.

12. Reinstall the C-pillar trim (A).

–1 Set the bottom hooks (B) of the trim to the rear

–2 Place the trim over the C-pillar (D), and fit its

Fastener Locations

13. Reinstall the rear door opening seal.

upper clip (E) and the lower clips into the holes

(F) in the C-pillar, then lightly push the trim into

• Make sure the side curtain airbag isn't tucked

down under the clips and ribs.

• Apply pressure to the areas of the trim on the

upper clip until these clip fittings are felt. If

you push too hard, the clip will be damaged,

and it will not hold the trim properly.

• Make sure the upper clip portions of the trim

don't come off the body by tugging on the

Chapters

Table of Contents