Honda Accord 2008 Manual page 1045

07/11/02 09:17:34 61TA0000_140_0202
Automatic Transmission
DTC Troubleshooting (cont'd)
9. Check for continuity between transmission range
switch connector terminals No. 1 and No. 10 when
the shift lever is in R, and when the shift lever is
shifted to any position other than R.
＊０３
TRANSMISSION RANGE SWITCH CONNECTOR
Is there continuity when the shif t lever is in R, and
no continuity when the shif t lever is shif ted to any
position other than R?
YES
NO −
(see page 14-291), then go to step 10.
10. Reconnect all connectors.
11. Turn the ignition switch to ON (II).
12. Clear the DTC with the HDS.
13. Start the engine with the shift lever in P. Shift to N
from P, then shift to R, and wait for at least
2 seconds.
14-200
ATP RVS
GND
Terminal side of male terminals
− Go to step 16.
Replace the transmission range switch
14. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P17 17 indicated?
YES − Check for poor connections or loose
terminals between the transmission range switch
and the PCM, then go to step 1.
−
NO Go to step 15.
15. Monitor the OBD STATUS for P1717 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 14,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the
transmission range switch and the PCM, then go to
step 1. If the HDS indicates NOT COMPLETED, go to
step 13.
16. Reconnect all connectors.
17. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
18. Start the engine with the shift lever in P. Shift to N
from P, then shift to R, and wait for at least
2 seconds.