Honda Accord 2008 Manual page 791

07/11/02 09:24:03 61TA0000_130_0018
Manual Transmission
Transmission Installation (cont'd)
12. Partially tighten the right rear subframe mounting
bolt (A); insert the frame position guide pin through
the positioning slot (B) on the rear stiffener,
through the positioning hole (C) on the subframe,
and into the positioning hole on the body, then
tighten the subframe mounting bolt.
＊０８
A
14 x 1.5 mm
103 N·m (10.5 kgf·m, 75.9 lbf·ft)
Replace.
12 x 1.25 mm
93 N·m (9.5 kgf·m, 69 lbf·ft)
Replace.
13. Partially tighten the left rear subframe mounting
bolt in the same manner as in step 12.
14. Partially tighten the right and left front subframe
mounting bolts.
15. Loosen the right rear mounting bolt, then tighten
the bolt to the specified torque with the guide pin in
the positioning hole.
16. Tighten the left rear mounting bolt to the specified
torque with the guide pin in the positioning hole.
17. Tighten the right and left front mounting bolt to the
specified torque.
18. Check that the positioning holes and slots are
aligned using the guide pin.
19. Tighten the rear and front stiffener mounting bolts
to the specified torque.
20. Remove the jack and front subframe adapter.
13-18
21. Install the power steering line holder bolt (A) and
the clamp (B).
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
C
B
22. Install the new lower transmission mount
mounting nuts.
070AG-SJAA10S
B
10 x 1.25 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
Replace.
＊０９
＊１０