Bearing Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:22:13 61TA0000_140_0330

Transmission Housing

Bearing Installation

Special Tools Required

• Attachment, 78 x 80 mm 07NAD-PX40100

• Driver 07749-0010000

• Attachment, 42 x 47 mm 07746-0010300

1. Install the bearings in the direction shown.

2. Expand each snap ring using snap ring pliers, and

install the mainshaft bearing (A), the secondary

shaft bearing (B), and the countershaft bearing (C)

part-way into the housing using the driver and the

78 x 80 mm attachment.

3. Release snap ring pliers, then push the bearing

down into the transmission housing until the snap

ring snaps in place around it.

4. Expand the snap ring of the idler gear shaft bearing

(A) using the snap ring pliers, and install the

bearing part-way into the housing using the driver

and the 42 x 47 mm attachment.

5. Release snap ring pliers, then push the bearing

down into the housing until the snap ring snaps in

place around it.

6. After installing the bearings check that the snap

rings (A) are seated in the bearing and the

transmission housing grooves, and that the snap

ring end gaps (B) are correct.

7. Install the idler gear shaft (see page 14-355).

ＴＡ０８ＡＥＢＥ１０４１１２３９５１１ＫＣＡＴ００

07749-0010000

07746-0010300

B: 0 7 mm (0 0.28 in.)

Table of Contents