Honda Accord 2008 Manual page 1712

07/11/02 09:34:11 61TA0000_200_0145
Two-Piece Type Rear Carpet
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
• Take care not to damage, wrinkle, or twist the carpet.
• Be careful not to damage the dashboard and other
interior trim pieces.
1. Remove the front seat belt lower anchors from the
front seats (except 2-door driver's seat), and
remove the seat mounting bolts (see page 20-180).
2. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
3. Remove these items:
• Front seats, both sides (see step 9 on page
20-183)
• Rear seat cushion (see page 20-224)
• Door sill trim, both sides, 2-door (see page 20-97)
• Driver's front seat belt lower anchor, 2-door (see
step 2 on page 24-5)
• Front door sill trim, both sides, 4-door (see page
20-99)
• Rear door sill trim, both sides, 4-door (see page
20-100)
• B-pillar lower trim, 4-door (see page 20-107)
• Center console (see page 20-147)
4. Remove the rear carpet (A).
–1 Remove the clips (B).
–2 On bottom of both rear side trim panels (C)
(2-door) or bottom of both B-pillars (4-door),
pull the carpet out to detach the clips (D).
–3 2-door: Pull out the edge of the carpet from
under both rear side trim panels.
–4 Pull the seat harnesses (E) out through the
holes in the carpet.
–5 Remove the grommets (F) from the body.
NOTE: Replace the clip (D) and the grommet (F)
as an assembly with a new one.
2-door
Fastener Locations
B : Clip, 2 D : Clip, 2
F
B
A
B
D
E
C
C
D
F
(cont'd)
20-143
＊１２