Honda Accord 2008 Manual page 1226

07/11/02 09:24:04 61TA0000_140_0383
Transmission End Cover
End Cover Installation
Special Tool Required
Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100
1. Install the mainshaft holder onto the mainshaft.
＊０１
07GAB-PF50101 or
07GAB-PF50100
2. Lubricate the following parts with ATF:
• Splines and threads of the mainshaft.
• Splines of the mainshaft idler gear.
• The old conical spring washer and the old locknut.
3. Install the mainshaft idler gear (A), the old conical
spring washer (B), and the old locknut (C) on the
mainshaft (D), and tighten the locknut to 226 N·m
(23.0 kgf·m, 166 lbf·ft).
NOTE:
• Do not tap the mainshaft idler gear to install.
• Use a torque wrench to tighten the locknut. Do
not use an impact wrench.
＊０２
C
B
A
D
4. Install the park lever (A) and the park lever stop (B)
on the selector control shaft (C), then install the
lock bolt with a new lock washer (D). Do not bend
the lock tab of the lock washer until step 18.
K
G
F
E
A
B
D
6 x 1.0 mm
14 N·m
(1.4 kgf·m,
10 lbf·ft)
C
5. Install the park pawl shaft (E), the park pawl spring
(F), the park pawl (G), and the stop shaft (H) on the
transmission housing.
6. Lubricate the following parts with ATF:
• Threads and splines of the countershaft.
• The old conical spring washer and the old locknut.
• Areas where the park gear contacts the conical
spring washer.
7. Install the park gear (I), the old conical spring
washer (J), and the old locknut (K) on the
countershaft.
8. Lift the park pawl up, and engage it with the park
gear, then tighten the locknut to 226 N·m
(23.0 kgf·m, 166 lbf·ft).
NOTE:
• Do not tap the park gear to install.
• Use a torque wrench to tighten the locknut. Do
not use an impact wrench.
• Countershaft locknut has left-hand threads.
9. Remove the locknuts and the conical spring
washers from the mainshaft and the countershaft.
ＴＡ０８ＡＥＢＥ１０４１０４２４２５１ＫＣＡＴ００
J
I
H
(cont'd)
14-381
＊０３