Honda Accord 2008 Manual page 1735

07/11/02 09:36:10 61TA0000_200_0168
Dashboard
Passenger's Middle Pad Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Take care not to scratch the dashboard, and its
related parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
2. Remove these items:
• Center pocket:
– Without navigation system (see page 20-154)
– With navigation system (see page 20-155)
• Passenger's dashboard trim (see page 20-159)
• Dashboard center vent (with navigation system)
(see page 20-163)
• Audio-HVAC module:
– Without navigation system (see page 23-111)
– With navigation system (see page 23-109)
• Passenger's dashboard side vent (see page
20-163)
• Passenger's airbag (see page 24-207)
20-166
3. Gently pull out along the edge of the passenger's
middle pad (A) to detach the hooks (B), then
remove the pad.
B
A
B
B
4. Install the pad in the reverse order of removal, and
note these items:
• Push the hooks into place securely.
• Do the battery terminal reconnection procedure
(see page 22-89).
• Check for any DTCs that may have been set
during repairs, and clear them.
ＴＡ０８Ａ００Ｊ２６２２０２１９３２４ＫＤＡＴ０４
B
＊０７