Honda Accord 2008 Manual page 1298

07/11/02 09:19:44 61TA0000_170_0032
7. Install the steering joint cover (A).
＊０８
8. Install the steering wheel (see page 17-27).
9. Do the battery terminal reconnection procedure
(see page 22-89), and do these tasks:
• Turn the ignition switch ON (II) and check that the
SRS indicator should come on for about 6
seconds and then go off.
• Make sure the horn and turn signal switches
work properly.
• Make sure the steering wheel switches work
properly.
10. After installation, do these checks:
• Check the steering wheel spoke angle. If the
steering spoke angles to the right and left are not
equal (steering wheel and rack are not centered),
correct the engagement of the joint/pinion shaft
splines.
• Set the steering column to the center tilt position,
and to the center telescopic position, then do the
front toe inspection (see page 18-5).
A
17-31