Honda Accord 2008 Manual page 1758

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:37:08 61TA0000_200_0191

3. Disconnect the slide motor connector (A), then

remove the slide motor (B) from the slide motor

bracket (C) while disconnecting the motor from the

short flex cable (D).

4. Remove the short flex cable (A) from the worm

gear (B) in the outer seat track by pulling out it.

5. Remove the motor end mounting (A) from the slide

6. Install the motor in the reverse order of removal,

and note these items:

• Apply multipurpose grease to the worm gear

portions in both seat tracks.

• Before installing the slide motor to the slide

motor bracket, install the short flex cable to the

slide motor.

• Before installing the slide motor bracket to the

seat tracks, make sure both seat tracks are

located forward fully.

• Make sure the short flex cable and the flex cable

are connected properly.

Chapters

Table of Contents