Honda Accord 2008 Manual page 1147

07/11/02 09:20:42 61TA0000_140_0304
A/T Interlock System
Shift Lock System Circuit Troubleshooting (cont'd)
15. Press the brake pedal.
Are the brake lights ON?
YES
NO −
16. Turn the ignition switch to LOCK (0).
17. Jump the SCS line with the HDS.
18. Disconnect PCM connector A (49P).
19. Measure the voltage between PCM connector
terminal A42 and body ground while pressing the
brake pedal and when the brake pedal is released.
＊０６
Is there battery voltage while pressing the brake
pedal, and about 0 V when the pedal is released?
YES
NO −
14-302
− Go to step 16.
Repair faulty brake light circuit.
PCM CONNECTOR A (49P)
BK SW (LT GRN)
Terminal side of female terminals
− Go to step 21.
Go to step 20.
20. Check for continuity between PCM connector
terminal A42 and brake pedal position switch 4P
connector terminal No. 2.
BRAKE PEDAL PCM CONNECTOR A (49P)
POSITION SWITCH
4P CONNECTOR
BK SW
(LT GRN)
Wire side of
female terminals
Is there continuity?
−
YES Substitute a known-good PCM (see page
14-8) and recheck.
NO − Repair open in the wire between PCM
connector terminal A42 and the brake pedal
position switch.
BK SW (LT GRN)
Terminal side of
female terminals
＊０７