Honda Accord 2008 Manual page 941

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 08:47:46 61TA0000_140_0098
Automatic Transmission
DTC Troubleshooting (cont'd)
12. Turn the ignition switch to LOCK (0).
13. Jump the SCS line with the HDS.
14. Disconnect PCM connector B (49P).
15. Connect shift solenoid wire harness connector
terminal No. 7 and body ground with a jumper wire.
*03
SHIFT SOLENOID WIRE HARNESS CONNECTOR
16. Check for continuity between PCM connector
terminal B34 and body ground.
*04
Is there continuity?
YES
NO
connector terminal B34 and the ATF temperature
sensor, then go to step 21.
14-96
SG2 (GRN/BLK)
JUMPER WIRE
Wire side of female terminals
PCM CONNECTOR B (49P)
SG2 (GRN/BLK)
Terminal side of female terminals
Go to step 27.
Repair open in the wire between PCM
17. Turn the ignition switch to LOCK (0).
18. Jump the SCS line with the HDS.
19. Disconnect PCM connector B (49P).
20. Check for continuity between PCM connector
terminal B28 and shift solenoid wire harness
connector terminal No. 6.
SHIFT SOLENOID WIRE
PCM CONNECTOR B (49P)
HARNESS CONNECTOR
ATFT
(RED/YEL)
Wire side of
female terminals
Is there continuity?
YES
Go to step 27.
NO
Repair open in the wire between PCM
connector terminal B28 and the ATF temperature
sensor, then go to step 21.
21. Reconnect all connectors.
22. Turn the ignition switch to ON (II).
23. Clear the DTC with the HDS.
24. Start the engine with the shift lever in P, and wait
for at least 20 seconds.
25. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 13 indicated?
YES
Check for poor connections or loose
terminals between the ATF temperature sensor and
the PCM, then go to step 1.
NO
Go to step 26.
ATFT (RED/YEL)
Terminal side of
female terminals
*05

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents