Transmission Range Switch Replacement - Honda Accord 2008 Manual

07/11/02 09:20:02 61TA0000_140_0293

Transmission Range Switch Replacement

1. Raise the vehicle on a lift, and make sure it is
securely supported.
2. Move the shift lever to N.
3. Remove the transmission range switch cover.
＊０１
4. Disconnect the transmission range switch
connector.
＊０２
5. Remove the transmission range switch.
6. Make sure the selector control shaft is in the N
position. If necessary, move the shift lever from P
to N.
NOTE: Do not use the selector control shaft to
adjust the shift position. If the selector control shaft
tips are squeezed together it will cause a faulty
signal or position due to play between the selector
control shaft and the transmission range switch.
7. Set a new transmission range switch (A) to the N
position. Align the cutouts (B) on the rotary-frame
with the neutral positioning cutouts (C) on the
transmission range switch, then put a 2.0 mm
(0.08 in.) feeler gauge blade (D) in the cutouts to
hold the transmission range switch in the N
position.
NOTE: Be sure to use a 2.0 mm (0.08 in.) blade or
equivalent to hold the transmission range switch in
the N position.
D
ＴＡ０８ＡＥＢＥ１０４１０７５９８１１ＫＢＡＴ００
A
C
B
(cont'd)
14-291
＊０３
＊０４