Intermediate Shaft Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:17:32 61TA0000_160_0027

Intermediate Shaft Installation

1. Make sure set ring is new. If it is not, replace the

2. Clean the areas where the intermediate shaft

contacts the differential thoroughly with solvent or

brake cleaner, and dry with compressed air.

NOTE: Do not wash the rubber parts with solvent.

3. Insert the intermediate shaft assembly (A) into the

differential until the set ring locks in the groove.

NOTE: Insert the intermediate shaft carefully to

prevent damaging the differential oil seal (B).

4. Install the flange bolt (A) and two dowel bolts (B).

10 x 1.25 mm

39 N·m (4.0 kgf·m, 29 lbf·ft)

5. Install the right driveshaft (see page 16-19).

6. Refill the transmission with the recommended

transmission fluid:

• Manual transmission (see page 13-5)

• Automatic transmission (see page 14-242)

7. Check the wheel alignment, and adjust it if

necessary (see page 18-5).

8. Test-drive the vehicle.

10 x 1.25 mm

ＴＡ０８ＡＥ４Ｅ１６２３６５０００００ＫＣＡＴ００

Table of Contents