Honda Accord 2008 Manual page 1731

07/11/02 09:36:09 61TA0000_200_0164
Dashboard
Glove Box Striker Replacement
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE: Take care not to scratch the dashboard and its
related parts.
1. Disconnect the glove box damper from the pivot on
the glove box (see page 20-160).
2. While holding the glove box, release the glove box
stop on each side from the dashboard by pushing
them inside (see step 5 on page 20-161).
3. Remove the screws, then remove the glove box
striker (A).
０１
Fastener Locations
: Screw, 2
4. Install the striker in the reverse order of removal.
20-162 20-162
ＴＡ０８Ａ００Ｊ２６２２０２３０１２２ＫＢＡＴ００
A
Dashboard Side Vent Removal/
Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
• The driver's side vent is shown; the passenger's side
vent is similar.
1. Remove these items:
• Driver's side: Driver's outer dashboard trim
(see page 20-153).
• Passenger's side: Passenger's dashboard trim
(see page 20-159).
• Passenger's side: Passenger's dashboard side lid
(see step 6 on page 20-161).
2. Driver's side: Open the front door, and remove the
driver's dashboard side lid (A).
–1 Pull out the front door opening seal (B) as
needed.
–2 Gently pry the rear edge of the lid with the
appropriate trim tool to detach the clips and
the hooks (C).
–3 Release the hooks (D).
Fastener Locations
: Clip, 3
C
A
C
C
ＴＡ０８Ａ００Ｊ２６２２０２１９２５１ＫＤＡＴ５０
D
D
B
＊０４