Honda Accord 2008 Manual page 1318

07/11/02 09:20:22 61TA0000_170_0052
41. Apply power steering fluid to the surface of the
pinion shaft (A). Slide the sleeve (B) onto the pinion
shaft by aligning the locating pin (C) on the pinion
shaft with the cutout (D) in the sleeve. Then install
the new snap ring (E) securely in the pinion shaft
groove. Be careful not to damage the valve seal
ring when installing the sleeve.
＊２９
42. Apply power steering fluid to the seal ring lip of the
new valve oil seal (A), then install the seal in the
valve housing (B) using a hydraulic press and
driver. Install the seal with its grooved side facing
the tool.
＊３０
07946-1870100
A
Replace.
43. Press the roller bearing (C) into the valve housing
with a hydraulic press and attachment.
C
A
07749-0010000
C
44. Apply vinyl tape (A) to the pinion shaft/sleeve (B),
then coat the vinyl tape with power steering fluid.
D
B
E
Replace.
D
Replace.
45. Insert the pinion shaft/sleeve into the valve housing
(C). Be careful not to damage the valve seal rings
(D).
46. Remove the vinyl tape from the pinion shaft, then
remove any residue from the tape adhesive.
47. Press the new valve oil seal (A) into the valve
housing with a hydraulic press. Check that the
pinion shaft/sleeve turns smoothly by hand after
installing it.
07JAD-PL9A100
B
48. Coat the piston seal ring guide with power steering
fluid, then slide it onto the rack, big end first.
C
A
B
07746-0030300
A
Replace.
＊３１
＊３２
(cont'd)
17-51