Honda Accord 2008 Manual page 1416

07/11/02 09:29:48 61TA0000_180_0083
TPMS indicator does not come on, and no
DTCs are stored
1. Turn the ignition switch to LOCK (0).
2. Disconnect the TPMS control unit 20P connector.
3. Turn the ignition switch to ON (II).
4. Check the TPMS indicator for several seconds
when the ignition switch is turned to ON (II).
Did the indicator come on?
−
YES Check for loose terminals and poor
connections at the TPMS control unit. If necessary,
substitute a known-good TPMS control unit
(see page 18-85), and recheck.
NO − Do the troubleshooting for the gauge control
module (see page 22-312). If necessary, substitute a
known-good gauge control module (see page
22-332), and recheck.
ＴＡ０８Ａ００Ｂ５４１７５１０００００ＦＡＡＴ０５
TPMS indicator does not go off, and no DTCs
are stored
NOTE: Check for gauge DTCs with the HDS (see page
22-3). If gauge DTCs are stored, troubleshoot those
DTCs first.
1. Turn the ignition switch to ON (II).
2. Check the TPMS indicator for several seconds
when the ignition switch is turned to ON (II).
Did the indicator come on and then go of f ?
−
YES The system is OK at this time.
NO − Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Check the No. 29 (7.5 A) fuse in the driver's under-
dash fuse/relay box.
Is the f use blown?
YES − Replace the No. 29 (7.5 A) fuse, and recheck.
If the fuse blows again, check for a short to body
ground in the wire between the TPMS control unit
and the No. 29 (7.5 A) fuse in the driver's under-
dash fuse/relay box.
NO − Reinstall the fuse, then go to step 5.
5. Check the No. 5 (7.5 A) fuse in the driver's under-
dash fuse/relay box.
Is the f use blown?
−
YES Replace the No. 5 (7.5 A) fuse, and recheck. If
the fuse blows again, check for a short to body
ground in the wire between the TPMS control unit
and the No. 5 (7.5 A) fuse in the driver's under-dash
fuse/relay box.
−
NO Reinstall the fuse, then go to step 6.
6. Disconnect the TPMS control unit 20P connector.
ＴＡ０８Ａ００Ｂ５４１７５１０００００ＦＡＡＴ０６
(cont'd)
18-83 18-83