Damper/Spring Removal And Installation - Honda Accord 2008 Manual

07/11/02 09:28:03 61TA0000_180_0031
35. Install all of the removed parts in the reverse order
of removal, and note these items:
• Refer to stabilizer link removal/installation to
connect the stabilizer bar to the links (see page
18-24).
• If the center guide is in place, use it to determine
the steering joint installation angle.
• If the center guide is gone, check the steering
joint installation angle (see step 3 on page 17-30).
• Check the steering wheel installation (see page
17-27).
• When connecting the rear engine mount to the
rear engine mount bracket, first lightly tighten
the mounting bolt, then remove the engine
support hanger, and tighten it to the specified
torque value.
• Before installing the wheel, clean the mating
surfaces of the brake disc and inside of the wheel.
• Check the wheel alignment, and adjust it if
necessary (see page 18-5).
36. Do the battery terminal reconnection procedure
(see page 22-89), then turn the ignition switch to
ON (II) and check that the SRS indicator should
come on for about 6 seconds and then go off.
Damper/Spring Removal and
Installation
Removal
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the front wheel.
3. Remove the wheel speed sensor harness bracket
mounting bolt (A).
4. Remove the damper pinch bolt (A) and the damper
fork mounting nut (B) while holding the mounting
bolt (C), then remove the damper fork (D) from the
damper and lower arm.
A
10 x 1.25 mm
D
B
12 x 1.25 mm
Replace.
ＴＡ０８Ａ００Ｂ２０２０００１９１０１ＫＤＡＴ００
＊０１
A
6 x 1.0 mm
＊０２
C
Replace.
(cont'd)
18-31 18-31