Shift Fork Clearance Inspection - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:24:37 61TA0000_130_0032

Manual Transmission

Shift Fork Clearance Inspection

NOTE: The synchro sleeve and synchro hub should be

replaced as a set.

1. Measure the clearance between each shift fork (A)

and its matching synchro sleeve (B). If the

clearance exceeds the service limit, go to step 2.

Service Limit: 1.0 mm (0.039 in.)

2. Measure the thickness of the shift fork fingers.

• If the thickness is not within the standard, replace

the shift fork.

• If the thickness is within the standard, replace the

synchro sleeve and synchro hub as a set.

• If one arm of the shift fork shows more wear than

others, the fork may be bent and needs to be

Standard: 7.4 7.6 mm (0.29 0.30 in.)

0.35 0.65 mm (0.014 0.026 in.)

3. Measure the clearance between the shift fork (A)

and the shift arm (B). If the clearance exceeds the

service limit, go to step 4.

0.2 0.5 mm (0.008 0.020 in.)

Service Limit: 0.6 mm (0.023 in.)

4. Measure the width of the shift arm.

• If the width is not within the standard, replace the

• If the width is within the standard, replace the

Standard: 16.9 17.0 mm (0.665 0.669 in.)

ＴＡ０８ＡＡ７Ｅ３４１５０３５４９０１ＭＡＡＴ００

Table of Contents