Rear Brake Disc Replacement - Honda Accord 2008 Manual

07/11/02 09:32:45 61TA0000_190_0034
Conventional Brake Components

Rear Brake Disc Replacement

NOTE: Keep any grease off the brake disc and brake
pads.
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the rear wheel.
3. Release the parking brake lever fully.
4. Loosen the parking brake cable adjusting nut
(see page 19-8).
5. Remove the flange bolt (A) from the arm (B).
＊０３
C
6. Disconnect the parking brake cable from the lever
(C).
19-34
7. Remove the brake hose mounting bolt (A).
C
D
B
8. Remove the brake caliper bracket mounting bolts
(B), and remove the caliper assembly (C) from the
knuckle. To prevent damage to the caliper
assembly or brake hose, use a short piece of wire
to hang the caliper assembly from the
undercarriage. Do not twist the brake hose and the
A
parking brake cable excessively.
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
NOTE: Make sure the plates (D) are in position on
16 lbf·ft)
reassembly, if they are removed (see step 5 on
page 18-39).
ＴＡ０８Ａ００Ｄ１４３０００１４７２１ＫＢＡＴ２０
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
B
12 x 1.25 mm
108 N·m
(11.0 kgf·m,
79.6 lbf·ft)
＊０４