Honda Accord 2008 Manual page 1639

07/11/02 09:30:25 61TA0000_200_0072
Glass
Rear Window Replacement (cont'd)
12. Apply primer to the edge of the rear window (A)
where the lower rubber dam adhesive tape will be
attached as shown. Attach the lower rubber dam
(B) with adhesive tape (C) to the lower edge of the
rear window:
• After installing the rubber dam, cut the ends (D)
of the rubber dam as shown.
• Be careful not to touch the windshield where
adhesive will be applied.
• 4-door is shown; 2-door is similar.
Lower rubber dam adhesive tape:
Thickness 0.2 mm (0.008 in.)
Width 4 mm (0.16 in.)
＊０７
149 mm
(5.87 in.)
20-70
: Apply primer here.
A
D
B
149 mm
(5.87 in.)
Inside Inside
A
5 mm
(0.2 in.)
B
13. Attach the upper rubber dam (A), the side rubber
dams (B), the upper clips (C), and the fasteners (D)
with adhesive tape to the inside face of the rear
window (E) as shown. Before installing the upper
clips, apply primer to the area where the adhesive
tape will be applied to the inside face of the
windshield:
• First attach the upper rubber dam, then attach the
side rubber dams around the edge of the rear
window. Be sure the top of the side rubber dam
contacts with the bottom of the upper rubber
dam. If necessary, cut the excess rubber dams.
• Be sure the upper clips and the fasteners line up
with the alignment marks (F).
• Be sure the convex portion (G) of the left and
right clips face toward the right.
• Be careful not to touch the rear window where
adhesive will be applied.
Upper clip adhesive tape:
Thickness 0.4 mm (0.016 in.)
Width 10 mm (0.39 in.)
Rubber dam adhesive tape:
A
Thickness 0.16 mm (0.006 in.)
Width 3.5 mm (0.14 in.)
Fastener adhesive tape:
Thickness 0.8 mm (0.03 in.)
Width 7 mm (0.28 in.)
2-door
149 mm
(5.87 in.)
B
A
C
F A
19 mm
(0.75 in.)
C
G
A
2 mm
(0.08 in.)
B
F
C
F
D
2 mm
(0.08 in.)
E
＊０８
2 mm
(0.08 in.)
B
D
B