Honda Accord 2008 Manual page 772

07/11/02 09:15:27 61TA0000_120_0021
Clutch Disc and Pressure Plate Installation
24. Temporarily install the clutch disc onto the splines
of the transmission mainshaft. Make sure the clutch
disc slides freely on the mainshaft.
25. Apply a light coat of super high temp urea grease
(P/N 08798-9002) to the crankshaft pilot bushing (A).
＊１５
D
07PAF-0020000
B
(P/N 08798-9002)
26. Apply super high temp urea grease (P/N 08798-
9002) to the splines (B) of the clutch disc (C), then
install the clutch disc using the clutch alignment
tool set (D).
27. Install the pressure plate (A) and the mounting
bolts (B) finger-tight.
＊１６
B
A
C
A
(P/N 08798-9002)
28. Torque the mounting bolts (A) in a crisscross
pattern. Tighten the bolts in several steps to
prevent warping the diaphragm spring.
Specified Torque: 25 N·m (2.6 kgf·m, 19 lbf·ft)
C
07PAF-0020000
B
07LAB-PV00100
29. Remove the ring gear holder (B) and the clutch
alignment tool set (C).
30. Make sure the diaphragm spring fingers are all the
same height.
A
(cont'd)
12-19
＊１７