Honda Accord 2008 Manual page 1559

07/11/02 09:37:15 61TA0000_190_0138
VSA System Components
Yaw Rate-Lateral Acceleration
Sensor Replacement
NOTE:
• Do not damage or drop the sensor as it is sensitive.
• Do not use power tools.
1. Turn the ignition switch to LOCK (0).
2. Remove the center console (see page 20-147).
3. Remove the yaw rate-lateral acceleration sensor
(A) mounting bolts.
＊０１
C
4. Disconnect the yaw rate-lateral acceleration sensor
5P connector (B).
5. Check for deformation in the bracket (C). If
necessary replace it.
6. Install the sensor in the reverse order of removal.
7. Do the VSA sensor neutral position memorization
(see page 19-138).
19-138 19-138
ＴＡ０８Ａ００Ｄ５２１０００６８０１１ＫＢＡＴ００
B
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
VSA Sensor Neutral Position
Memorization
NOTE: Do not press the brake pedal during this
procedure.
1. Park the vehicle on a flat and level surface, with the
steering wheel in the straight ahead position.
2. With the ignition switch in LOCK (0), connect the
HDS to the data link connector (DLC) (A) under the
driver's side of the dashboard.
A
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle
and the VSA modulator-control unit. If it doesn't,
troubleshoot the DLC circuit (see page 11-208).
5. Select VSA ADJUSTMENT with the HDS, and
follow the screen prompts.
NOTE: See the HDS Help menu for specific
instructions.
6. Turn the ignition switch to LOCK (0).
ＴＡ０８Ａ００Ｄ５２１０００６３６５３ＢＢＡＴ００
＊０１