Honda Accord 2008 Manual page 1646

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:30:28 61TA0000_200_0079

Cutting positions

6. From inside the vehicle, cut through the adhesive

(A) of quarter glass rear corner and the rear clip (B)

with a utility knife (C).

7. With a putty knife, scrape the old adhesive smooth

to a thickness of about 2 mm (0.08 in.) on the

bonding surface around the entire quarter glass

opening flange:

• Do not scrape down to the painted surface of the

body; damaged paint will interfere with proper

• Remove the clips from the body.

8. Clean the body bonding surface with a sponge

dampened in isopropyl alcohol. After cleaning,

keep oil, grease, and water from getting on the

9. Remove the quarter glass molding from the quarter

glass. If the old quarter glass molding is to be

reinstalled, replace the molding clips with new

10. If the old quarter glass is to be reinstalled, use a

putty knife to scrape off all of the old adhesive and

the damaged clips from the quarter glass. Clean the

inside face and the edge of the quarter glass with

isopropyl alcohol where new adhesive is to be

applied. Make sure the bonding surface is kept free

of water, oil, and grease.

Chapters

Table of Contents