Honda Accord 2008 Manual page 1438

07/11/02 09:31:47 61TA0000_190_0017
Replacement - AKEBONO Type
1. Remove some brake fluid from the master cylinder.
2. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
3. Remove the front wheels.
4. Remove the brake hose mounting bolt (A).
＊１２
A
8 x 1.25 mm
B
8 x 1.0 mm
5. Remove the flange bolt (B), and pivot the caliper (C)
up out of the way. Check the hose and pin boots for
damage and deterioration.
6. Remove the pad shims (A) and the brake pads (B).
＊１３
A
C
A
B
7. Remove the pad retainers (A).
C
A
C
8. Clean the caliper bracket (B) thoroughly; remove
any rust, and check for grooves and cracks.
Verify that the caliper pins (C) move in and out
smoothly. Clean and lube if needed.
9. Inspect the brake disc, and check for damage and
cracks (see page 19-20).
10. Apply a thin coat of M-77 assembly paste (P/N
08798-9010) to the retainers on their mating
surfaces (indicated by the arrows) against the
caliper bracket.
11. Install the pad retainers. Wipe excess assembly
paste off the retainers. Keep the assembly paste off
the brake disc and the brake pads.
＊１４
B
(cont'd)
19-17