Honda Accord 2008 Manual page 1713

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:34:12 61TA0000_200_0146

Interior Trim

Carpet Replacement (cont'd)

Fastener Locations

5. If necessary, remove the staples (A) by prying them

with a flat-tip screwdriver, then remove the hook

6. If the hook (A) is removed, reinstall the hook to the

carpet (B) with new staples (C); fit the projection (D)

of the hook to the notch in the carpet, then staple

the hook. From face of the carpet, bend the

projected staple with a flat-tip screwdriver.

Staple: Height 13 mm (0.51 in.)

7. Install the carpet in the reverse order of removal,

and note these items:

• Take care not to damage, wrinkle or twist the

• Make sure the seat harnesses are routed

• Slip the holes in the carpet over the rear heater

• If the clips fastening the carpet to the floor are

damaged or stress-whitened, replace them with

• Replace the clips fastening the carpet to both

door sill areas with new ones.

• Push the clips into place securely.

• 2-door: Slip the carpet under both rear side trim

panels properly.

• Do the battery terminal reconnection procedure

(see page 22-89).

Width 12 mm (0.47 in.)

Thickness 0.5 mm (0.02 in.)

Chapters

Table of Contents