Honda Accord 2008 Manual page 1638

07/11/02 09:30:24 61TA0000_200_0071
Cutting positions - 2-door
＊０５
A
A
Cutting positions - 4-door
＊０６
A
A
A
C
B
A
A
C
B
A
8. Carefully remove the rear window.
9. With a putty knife, scrape the old adhesive smooth
to a thickness of about 2 mm (0.08 in.) on the
bonding surface around the entire rear window
opening flange:
• Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper
bonding.
• Remove the fasteners from the body.
10. Clean the body bonding surface with a sponge
dampened in alcohol. After cleaning, keep oil,
grease, and water from getting on the surface.
A
11. If the old rear window will be reinstalled, use a
putty knife to scrape off all of the old adhesive, the
fasteners, and the rubber dams from the rear
window. Clean the inside face and the edge of the
rear window with alcohol where new adhesive will
be applied. Make sure the bonding surface is kept
free of water, oil, and grease.
A
(cont'd)
20-69