Honda Accord 2008 Manual page 1688

07/11/02 09:33:14 61TA0000_200_0121
Trim Removal/Installation - Rear Shelf Area
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
Rear Shelf
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the rear shelf and the
trim.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
• Rear seat cushion, 4-door (see page 20-224)
• Rear seat side bolster, both sides, 4-door
(see page 20-224)
• Rear door opening seal, as needed, 4-door (see
step 3 on page 20-101)
• C-pillar trim, both sides:
– 2-door (see page 20- 110)
– 4-door (see page 20- 115)
2. From the trunk compartment, turn the high mount
brake light socket (A) 45 ° counterclockwise to
remove the socket. 4-door is shown; 2-door is
similar.
＊０９
3. For some models: Disconnect the ANC rear
microphone subharness connector (A).
2-door
A
4-door
A
A
ＴＡ０８Ａ００Ｊ２６２７３４０００００ＫＤＡＴ１３
＊１０
＊１１
(cont'd)
20-119