Honda Accord 2008 Manual page 1224

07/11/02 09:24:02 61TA0000_140_0381
14. Install the three dowel pins (A) and a new gasket (B)
on the torque converter housing (C).
＊０７
E
D
A
15. Align the spring pin of the selector control shaft (D)
with the transmission housing groove (E) by
turning the selector control shaft. Do not squeeze
the end of the selector control shaft tips together
when turning the selector control shaft. If the tips
are squeezed together, it will cause a faulty shift
position signal or position due to the play between
the selector control shaft and the transmission
range switch.
16. Place the transmission housing (F) on the torque
converter housing. Do not install the mainshaft and
countershaft speed sensors before installing the
transmission housing on the torque converter
housing.
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)
F
A
17. Wrap a screwdriver tip with tape to prevent
damage to the reverse idler gear teeth. Engage the
reverse idler gear with reverse gears by rotating
the idler gear using the screwdriver.
B
18. Install the transmission housing mounting bolts,
and tighten the 19 bolts to 44 N·m (4.5 kgf·m,
33 lbf·ft) in at least two steps, in a crisscross pattern.
C
＊０８
(cont'd)
14-379