Honda Accord 2008 Manual page 1003

07/11/02 08:49:06 61TA0000_140_0160
Automatic Transmission
DTC Troubleshooting (cont'd)
12. Disconnect the A/T clutch pressure control solenoid
valve A connector.
13. Measure the resistance between A/T clutch
pressure control solenoid valve A connector
terminals No. 1 and No. 2.
＊０１
Is there 3 10
YES
NO −
valve A (see page 14-230), then go to step 19.
14. Check for continuity between A/T clutch pressure
control solenoid valve A connector terminal No. 2
and body ground.
＊０２
Is there continuity?
YES
−
NO
pressure control solenoid valve A and ground
(G101) (see page 22-22), or repair poor ground
(G101), then go to step 19.
14-158
A/T CLUTCH PRESSURE CONTROL
SOLENOID VALVE A CONNECTOR
Terminal side of male terminals
− ?
− Go to step 14.
Replace A/T clutch pressure control solenoid
A/T CLUTCH PRESSURE CONTROL
SOLENOID VALVE A CONNECTOR
GND (BLK)
Wire side of female terminals
− Go to step 15.
Repair open in the wire between A/T clutch
15. Jump the SCS line with the HDS.
16. Disconnect PCM connector B (49P).
17. Check for continuity between A/T clutch pressure
control solenoid valve A connector terminal No. 1
and body ground.
A/T CLUTCH PRESSURE CONTROL
SOLENOID VALVE A CONNECTOR
LS A (RED/BLK)
Wire side of female terminals
Is there continuity?
YES − Repair short to body ground in the wire
between A/T clutch pressure control solenoid valve
A connector terminal No. 1 and body ground, then
go to step 19.
NO − Go to step 18.
＊０３