Honda Accord 2008 Manual page 1699

07/11/02 09:33:19 61TA0000_200_0132
Interior Trim
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend and scratch the headliner.
• Be careful not to damage the dashboard and other
interior trim.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the front seat belt lower anchor from the
driver's seat, and remove the driver's seat
mounting bolts (see page 20-180).
2. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
3. Remove these items:
• 2-door:
– A-pillar trim, both sides (see page 20-101)
– Ceiling light (see page 22-235)
– B-pillar upper trim (see page 20-105)
– C-pillar trim (see page 20-110)
– Sunvisors and holders, both sides (see page
20-126)
– Grab handles, two places (see page 20-128)
– Driver's dashboard lower cover (see page
20-152)
– Passenger's kick panel (see page 20-97)
– Glove box (see page 20-160)
• 4-door:
– A-pillar trim, both sides (see page 20-101)
– Ceiling light (see page 22-235)
– B-pillar lower trim, both sides (see page
20-107)
– B-pillar upper trim, both sides (see page
20-107)
– C-pillar trim, both sides (see page 20-115)
– Sunvisors and holders, both sides (see page
20-126)
– Grab handles, four places (see page 20-128)
– Driver's dashboard lower cover (see page
20-152)
– Passenger's kick panel (see page 20-99)
– Glove box (see page 20-160)
– Driver's front seat (see step 9 on page 20-183)
20-130
4. Remove the roof console (A).
–1 Remove the lenses (B).
–2 Remove the screws (C), then pull out the front
individual map light (D).
–3 Disconnect the front individual map light
connector (E). If equipped, disconnect the
moonroof switch connector (F).
–4 Remove the screws (G). Pull out the front side
of the console, and release the rear hooks (H).
–5 If equipped, disconnect the navigation
microphone connector or the ANC front
microphone connector (I).
Fastener Locations
C : Screw, 2 G
: Screw, 2
(Silver) (Black)
E
G
D
C
B
ＴＡ０８Ａ００Ｊ２６２０００３１２０１ＫＤＡＴ００
I
F
H
A
G
C
＊０１