Honda Accord 2008 Manual page 1362

07/11/02 09:28:02 61TA0000_180_0029
24. Remove the flange bolts (A) on both sides of the
front subframe rear bracket (B).
＊１３
25. Loosen the rear side of the front subframe
mounting bolts (C) until there is 30 mm (1 3/16 in.)
distance between the bolt seat and the mounting
surface. Do not loosen the mounting bolts more
than necessary.
26. Lower the transmission jack with the front
subframe adapter slowly until the front subframe
(D) has dropped about 30 mm (1 3/16 in.).
NOTE: Do not try to lower the front subframe
beyond the loosened subframe mounting bolts
clearance.
D
30 mm
(1 3/16 in.)
A
C
12 x 1.25 mm
14 x 1.5 mm
Replace.
27. Remove the flange bolts (A) and the bushing
holders (B), then remove the bushings (C).
NOTE: During installation, align the paint marks (D)
on the stabilizer bar with the side of the bushings.
B
B
28. Move the stabilizer bar toward the passenger's side,
and remove the stabilizer bar.
29. Install the stabilizer bar.
NOTE:
• Note the right and left direction of the stabilizer
bar.
• Note the direction of installation for the bushings.
A
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)
D
FRONT
C
(cont'd)
18-29
＊１４