Honda Accord 2008 Manual page 1660

07/11/02 09:31:14 61TA0000_200_0093
10. Install the frame and the drain tube in the reverse
order of removal, and note these items:
• Before installing the frame, clear the drain tubes
and the drain valves using compressed air.
• When installing, tie the string that was left in the
pillar to the top end of the new drain tube and
pull it up into the roof.
• Check the frame seal.
• Clean the surface of the frame.
• When installing the frame, first attach the rear
hooks into the body holes.
• Make sure the connectors are plugged in
properly.
• When connecting the drain tube, slide it over the
frame nozzle at least 10 mm (0.39 in.).
• Install the tube clip (A) on the drain tube (B) as
shown.
• After all parts are installed, including the
headliner, reset the moonroof control unit
(see page 22-350).
• Do the glass position alignment procedure
(see page 20-83).
＊０９
Upward
11. Check for water leaks. Let the water run freely from
a hose without a nozzle. Do not use a high-pressure
spray.
Drain Channel Slider and Cable
Assembly Replacement
1. Remove the frame (see page 20-88).
2. Remove these parts from the frame:
• Sunshade (see page 20-87)
• Moonroof motor (see page 20-88)
3. Remove the aluminum tape (A). 4-door: Detach the
clips (B) securing the moonroof subharness (C).
4-door is shown; 2-door is similar.
4. Put on gloves to protect your hands. Remove the
screws (A), and remove the screws (B) securing the
cable tube rear brackets (C). Remove the cable tube
side bracket mounting bolts (D) and the cable tube
A
mounting screws (E) from both sides of the frame
(F). 4-door is shown; 2-door is similar.
Fastener Locations
A
B
E
ＴＡ０８ＡＢ９Ｊ３４２０００４０７０２ＫＢＡＴ１０
B
A
: Screw, 2 B : Screw, 2 D
: Screw, 2
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
F
D
E
C
: Bolt, 6
B C
(cont'd)
20-91 20-91
＊０１
＊０２