Honda Accord 2008 Manual page 1131

07/11/02 09:19:56 61TA0000_140_0288
Automatic Transmission
Shift Cable Adjustment (cont'd)
15. Push the retainer lock (A) fully to lock the socket
holder retainer (B), and make sure that the retainer
lock fits into the hinged-joint (C). If the retainer lock
does not fit with the edge of the hinged-joint, rotate
the holder retainer counterclockwise while pushing
the retainer lock until it locks.
＊１２
16. Check that the shift cable end is properly installed
on the mounting stud.
＊１３
17. If the cable end is out of position on the mounting
stud, remove the shift cable from the bracket, and
reinstall the shift cable. Do not install the shift cable
end on the mounting stud while the shift cable is on
the bracket.
If the cable end rides on the bottom of the
mounting stud, rotate the stud and align the square
fitting with the hole.
14-286
A
C
B
A
Improperly installed:
Cable end
positions
out of the
mounting stud.
Cable end rides
on the bottom
of the mounting
stud.
Properly installed:
18. Install and tighten the nut on the shift cable end.
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
19. Remove the 6.0 mm (0.24 in.) pin that was installed
to hold the shift lever.
20. Turn the ignition switch to ON (II). Move the shift
lever to each position, and check that the A/T gear
position indicator follows the transmission range
switch.
21. Shift the shift lever to P, and check that the shift
lock works properly. Push the shift lock release, and
check that the shift lever releases, and also check
that the shift lever locks when it is shifted back to P.
22. Install these items:
• Center console (see page 20-147)
• Center console rear trim (see page 20-148)
• Center console panel (see page 20-145)
＊１４