Honda Accord 2008 Manual page 1330

07/11/02 09:20:41 61TA0000_170_0064
34. Loosely connect the return line and inlet line to the
valve housing by hand.
35. Install the return line clamp bolt (A), and tighten it
to the specified torque.
＊１９
36. Install the return line (B) to the return hose clamp
(C), and clamp it.
37. Install the inlet line clamp bracket bolt (A) and the
return hose clamp bracket bolt (B), and tighten
them to the specified torque.
＊２０
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
D
38. Install the return hose (C) to the return hose clamp
(D), and clamp it.
A
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
C
B
B
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
C
39. Install the inlet line clamp bracket bolt (A) and the
return line clamp bracket bolt (B), and tighten them
to the specified torque.
B
6 x 1.0 mm
A
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
18 x 1.5 mm
47 N·m
(4.8 kgf·m, 35 lbf·ft)
40. Tighten the flare nuts to the specified torque.
41. Install the P/S heat shield (A) with the flange bolts,
and tighten them to the specified torque.
A
42. Install the strut brace (see page 20-287).
43. Place a floor jack under the lower arm, and raise
the suspension to load it with the vehicle's weight.
Do not place the jack against the ball joint pin of the
knukele. Tighten the damper fork mounting nut
while holding the mounting bold to the specified
torque (see step 28).
44. Install the front wheels, then set the wheels in the
straight ahead position.
NOTE: Before installing the wheel, clean the mating
surfaces of the brake disc and the inside of the
wheel.
16 x 1.5 mm
28 N·m
(2.9 kgf·m, 21 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
(cont'd)
17-63
＊２１
＊２２