Stabilizer Link Removal/Installation - Honda Accord 2008 Manual

07/11/02 09:27:59 61TA0000_180_0024
Front Suspension
Lower Arm Removal/Installation
(cont'd)
4. Clean the mating surfaces of the new compliance
bushing (A) and the lower arm (B).
＊０７
E
C
2 0.5 mm ±
(0.08 0.02 in.) ±
5. Make sure of the compliance bushing installation
direction, align the bushing aligning marks with the
lower arm, then press in the bushing into the lower
arm using the bushing driver, the bushing receiver
set (attachments A and B), and a hydraulic press.
NOTE:
• Press in the bushing from the bottom side of the
lower arm.
• After installation, check the protrusion (C) of the
bushing outer sleeve (D) through the lower arm
bushing hole (E).
6. Install the lower arm.
18-24 18-24
Press
D
070AF-TA0A100
UPPER SIDE
in the VEHICLE
070AF-TA0A220
(Attachment B)
070AF-TA0A220
(Attachment A)

Stabilizer Link Removal/Installation

1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the front wheel.
3. Remove the self-locking nut (A) and the flange nut
(B) while holding the respective joint pin (C) with a
hex wrench (D), then remove the stabilizer link (E).
A E
H
B
B
10 x 1.25 mm
39 N·m
(4.0 kgf·m, 29 lbf·ft)
Replace.
4. Install the stabilizer link on the stabilizer bar (F) and
the lower arm (G) with the joint pins set at the
center of their range of movement.
NOTE: The stabilizer link has a paint mark (H). The
left stabilizer link is marked with yellow paint, and
the right stabilizer link is marked with white paint.
5. Install the new self-locking nut and the new flange
nut, and tighten them to specified torque values
while holding the respective joint pin with a hex
wrench.
6. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheel.
7. Test-drive the vehicle.
8. After 5 minutes of driving, tighten the self-locking
nut again to the specified torque value.
ＴＡ０８Ａ００Ｂ２０２０００５６８６１ＫＤＡＴ００
F A
10 x 1.25 mm
38 N·m
(3.9 kgf·m,
28 lbf·ft)
Replace.
G
D
C
＊０１