Honda Accord 2008 Manual page 1015

07/11/02 09:15:56 61TA0000_140_0172
Automatic Transmission
DTC Troubleshooting (cont'd)
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Clear the DTC with the HDS.
19. Start the engine, and wait for at least 1 second.
20. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P097 0 indicated?
YES − Check for poor connections or loose
terminals between A/T clutch pressure control
solenoid valve C and the PCM, then go to step 1.
NO − Go to step 21.
21. Monitor the OBD STATUS for P0970 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 20,
go to the indicated DTC's troubleshooting.
−
NO If the HDS indicates FAILED, check for poor
connections or loose terminals between A/T clutch
pressure control solenoid valve C and the PCM,
then go to step 1. If the HDS indicates NOT
COMPLETED, go to step 19.
14-170
22. Reconnect all connectors.
23. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
24. Start the engine, and wait for at least 1 second.
25. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P097 0 indicated?
YES − Check for poor connections or loose
terminals between A/T clutch pressure control
solenoid valve C and the PCM. If the PCM was
updated, substitute a known-good PCM (see page
14-8), then go to step 24. If the PCM was substituted,
go to step 1.
NO − Go to step 26.
26. Monitor the OBD STATUS for P0970 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-232). If any other
Temporary DTCs or DTCs were indicated in step 25,
go to the indicated DTC's troubleshooting.
−
NO If the HDS indicates FAILED, check for poor
connections or loose terminals between A/T clutch
pressure control solenoid valve C and the PCM. If
the PCM was updated, substitute a known-good
PCM (see page 14-8), then go to step 24. If the PCM
was substituted, go to step 1. If the HDS indicates
NOT COMPLETED, go to step 24.