Honda Accord 2008 Manual page 922

07/11/02 08:47:19 61TA0000_140_0079
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-position Input)
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
• This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. With the brake pedal pressed, move the shift lever
through all positions. Stop for at least 1 second in
each position.
5. Monitor the OBD STATUS for P0705 in the DTCs
MENU with the HDS.
Does the HDS indicate F AILED?
−
YES Go to step 6.
NO − If the HDS indicates PASSED, intermittent
failure, the system is OK at this time. Check for
intermittent short to body ground in the wires
between the transmission range switch and the
PCM. If the HDS indicates NOT COMPLETED, go to
step 3.
6. Turn the ignition switch to LOCK (0).
7. Inspect the transmission range switch (see page
14-289).
Is the switch OK ?
YES − With the switch connector disconnected, go
to step 8.
−
NO Replace the transmission range switch
(see page 14-291), then go to step 50.
8. Turn the ignition switch to ON (II).
9. Measure the voltage between transmission range
switch connector terminals No. 6 and No. 10.
TRANSMISSION RANGE SWITCH CONNECTOR
ATP P (BLK/BLU)
Wire side of female terminals
Is there more than 5 V ?
−
YES Go to step 15.
NO − Go to step 10.
ＴＡ０８ＡＥＢＫ７７１０００９０７０５ＦＡＡＴ００
GND (BLK)
(cont'd)
14-77
＊０１