Honda Accord 2008 Manual page 1102

07/11/02 09:18:51 61TA0000_140_0259
11. Install new set ring (A) on the intermediate shaft (B).
＊０８
12. Clean the areas where the intermediate shaft
contacts the transmission (differential) with solvent,
and dry with compressed air. Apply ATF to the
intermediate shaft splines (C), then install the
intermediate shaft. Be sure not to allow dust or
other foreign particles to enter the transmission.
13. Install new set ring (A) on the left driveshaft (B).
＊０９
10 x 1.25 mm
39 N·m
B
C
(4.0 kgf·m, 29 lbf·ft)
B
A
14. Clean the areas where the left driveshaft contacts
the transmission (differential) with solvent, and dry
with compressed air. Then install the left driveshaft.
Be sure not to allow dust or other foreign particles
to enter the transmission. Turn the steering knuckle
fully outward, and slide the driveshaft into the
differential until you feel its set ring fully engage
the side gear.
15. Apply the super high-temp urea grease
(P/N 08798-9002) to the right driveshaft inboard-
joint splines.
A
16. Slide the right driveshaft over the intermediate
shaft splines until you feel the driveshaft fully
engage the intermediate shaft set ring.
17. Install the transmission lower mounts with new
bolts.
10 x 1.25 mm
54 N·m (5.5 kgf·m, 40 lbf·ft)
Replace.
(cont'd)
14-257
＊１０