Main Valve Body Disassembly, Inspection, And Reassembly - Honda Accord 2008 Manual

07/11/02 09:22:16 61TA0000_140_0336
Valve Body

Main Valve Body Disassembly, Inspection, and Reassembly

1. Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages.
2. Do not use a magnet to remove the check balls, it may magnetize the balls.
3. Inspect the valve body for scoring and damage.
4. Check all valves for free movement. If any fail to slide freely, refer to the valve body repair procedure (see page
14-332).
5. Coat all parts with ATF during assembly.
＊０１
MANUAL VALVE
SPRING SPECIFICATIONS
A
B
C
D
E
F
G
H
14-334
ＴＡ０８ＡＥＢＥ１０４８０１３９３０１ＭＥＡＴ００
SHIFT VALVE B
SHIFT VALVE C
CHECK BALL
ROLLER
SERVO CONTROL VALVE
VALVE CAP
G
H
VALVE CAP CLIP
Springs
Shift valve A spring
Shift valve B spring
Shift valve C spring
Relief valve spring
Lock-up control valve spring
Cooler check valve spring
Servo control valve spring
Shift valve E spring
A
SHIFT VALVE A
CHECK BALL
SHIFT VALVE E
MAIN VALVE BODY
Standard (New)-Unit: mm (in.)
Wire Diameter
0.8 (0.031) 5.6 (0.220)
0.8 (0.031) 5.6 (0.220)
0.8 (0.031) 5.6 (0.220)
1.0 (0.039) 9.6 (0.378)
0.65 (0.026) 7.1 (0.280)
0.85 (0.033) 6.6 (0.260)
0.7 (0.028) 6.6 (0.260)
0.8 (0.031) 5.6 (0.220)
SPRING SEAT
RELIEF VALVE
B
C
VALVE SLEEVE
D
LOCK-UP
F E
CONTROL
VALVE
COOLER CHECK
VALVE
O.D. Free Length No. of Coils
28.1 (1.106)
28.1 (1.106)
28.1 (1.106)
34.1 (1.343)
23.1 (0.909)
27.0 (1.063)
35.7 (1.406)
28.1 (1.106)
15.9
15.9
15.9
10.2
12.7
11.3
17.2
15.9