Honda Accord 2008 Manual page 1105

07/11/02 09:19:16 61TA0000_140_0262
Automatic Transmission
Transmission Installation (cont'd)
31. Saitama Factory produced models: Apply
molybdenum grease to the hole in the bushing (A)
in the shift cable end (B). Attach the shift cable end
to the control lever (C), then insert the control pin
(D) into the control lever hole through the shift
cable end, and secure the control pin with the
spring clip (E). Do not bend the shift cable
excessively.
＊１６
F
H
32. Saitama Factory produced models: Install the shift
cable bracket (F) with the bolts (G).
33. Saitama Factory produced models: Install the shift
cable cover (H).
14-260
B
G
6 x 1.0 mm
6 x 1.0 mm
9.8 N·m
12 N·m
(1.0 kgf·m,
(1.2 kgf·m, 8.7 lbf·ft)
7.2 lbf·ft)
34. Marysville, Ohio Factory produced models: Install
the control lever (A) over the selector control shaft
(B). Secure the control lever with a new lock
washer (C) and the lock bolt (D), then bend the lock
tab of the lock washer against the bolt head.
C
D
E
E
A
G
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
35. Marysville, Ohio Factory produced models: Install
the shift cable bracket (E) with the bolts (F).
36. Marysville, Ohio Factory produced models: Install
the shift cable cover (G).
37. Install the shift cable on the shift lever, and adjust
the shift cable (see page 14-283).
B
A
C
Replace.
D
6 x 1.0 mm
14 N·m
(1.4 kgf·m,
10.1 lbf·ft)
F
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
＊１７