Honda Accord 2008 Manual page 1259

07/11/02 09:17:18 61TA0000_160_0020
Driveline/Axle
Driveshaft Installation (cont'd)
6. Install the outboard joint (A) into the front wheel
hub (B).
＊０５
7. Wipe off any grease contamination from the ball
joint tapered section and threads, then install the
knuckle (A) onto the lower arm (B). Be careful not to
damage the ball joint boot (C). Wipe off the grease
before tightening the nut at the ball joint. Torque
the new castle nut (D) to the lower torque
specification, then tighten it only far enough to
align the slot with the ball joint pin hole.
NOTE:
• Make sure the ball joint boot is not damaged or
cracked.
• Do not align the nut by loosening it.
＊０６
A
C
B
8. Install a new cotter pin (E) into the ball joint pin
hole, and bend the cotter pin as shown.
16-20
A
D
14 x 1.5 mm
78 88 N·m −
E
−
(8.0 9.0 kgf·m,
Replace.
−
58 65 lbf·ft)
Replace.
9. Connect the front stabilizer link (A) to the lower arm,
and loosely install a new flange nut. Hold the
stabilizer link ball joint pin (B) with a hex wrench (C),
and tighten the new flange nut (D).
B
C
D
10 x 1.25 mm
44 N·m
(4.5 kgf·m,
32 lbf·ft)
Replace.
10. Install the damper fork (A) over the driveshaft and
onto the lower arm. Install the damper in the
damper fork so the aligning tab (B) is aligned with
the slot in the damper fork. Loosely install the
damper pinch bolt (C).
C
10 x 1.25 mm
49 N·m
(5.0 kgf·m,
36 lbf·ft)
E
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
FRONT
47 lbf·ft)
Replace.
11. Loosely install a new damper fork mounting bolt
FRONT
(D) and a new damper fork mounting nut (E).
A
B
B
A
D
Replace.
＊０７
＊０８