Honda Accord 2008 Manual page 1733

07/11/02 09:36:10 61TA0000_200_0166
Dashboard
Dashboard Center Vent Removal/
Installation (cont'd)
2. Pull out the dashboard center vent (A) by hand to
detach lower clips and release the projections (B)
from the holes in the center display visor (C), then
remove the panel.
＊０２
Fastener Locations
: Clip, 4
A
3. Disconnect the hazard warning switch/passenger's
airbag off indicator connector (D) and the
navigation subdisplay connector (E). Detach the
harness clip (F), and release the wire harness (G)
from the harness holder (H).
4. Install the vent in the reverse order of removal, and
note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Make sure all connectors are plugged in properly.
• Push the harness clip and the clips into place
securely.
20-164 20-164
C
B
E
G
D
H
F
Side Defogger Vent Trim Removal/
Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
Driver's Side
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Insert the appropriate trim tool into a gap between
the side defogger vent trim (A) and the driver's
outer middle pad (B), and detach the lower clips (C).
Fastener Locations
C, D : Clip, 3
B
2. Pull out the trim to detach the upper clip (D), then
remove the trim.
3. Install the trim in the reverse order of removal, and
note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Push the clips into place securely.
ＴＡ０８Ａ００Ｊ２６２２０２１９２５１ＫＤＡＴ００
A
D
C
C
＊０３